How to hack your Ranga fountain pen to accept Zebra G nibs.

Do note:

  • This hack will work for almost any fountain pen with an ebonite feed, friction-fit into the section. (Like the Noodler’s Ahab or Konrad, for example.)
  • If we’re talking experience from innocent bystander to supreme boss ninja, this hack is serious apprentice level.
  • Enthusiastic beginner? Please have a spare pen.

Why do this hack when there’s an almost-no-effort Jinhao hack?

  • Ranga fountain pens are eyedroppers and come with ebonite feeds; both will definitely help when it comes to the increased ink flow that flexible nibs like the Zebra G require.
  • Because they’re friction-fit, the nib and feed pull out easily, and require little effort to push back into place after cleaning. You’ll be doing this quite often if you want your Zebra G nibs to last longer.

What’s the big deal with Zebra G nibs anyway?

  • Consistent flex performance from nib to nib
  • Reliable supply
  • Choice between original and titanium-coated

Here’s the how-to video:

I covered most of these points in the video, but it never hurts to review:

Nibs need to be flush to the feed for the ink to find its way to the tip, and the paper.

The Ranga feed is just a little too big for the underside of the Zebra G nib to be able to stay in contact with its surface. Like so:

So the task is to shave the feed down, with care, caution, and good lighting. I used the blade in my Leatherman Squirt, but a craft knife should work as well. Ebonite is pretty soft so take it easy.

Keep checking the fit of nib and feed into the section so you don’t shave off more than what’s needed to ensure a snug fit. Don’t shave down all the way to the base. Leave the circumference at the base intact so the feed sits in the section as it was sized to.

chamfered2

With a little pressure, you should be able to see the gap between the nib and the feed closing.

nowitfits

I can’t repeat this enough: be patient!

Check that there’s no gap between the nib and feed when inserted into the section.

underside

I’ve not done a single hack where the flow was right the first time. To check what’s going on, put ink in the pen. Flick the pen to get ink to the feed. Write with it until the ink stops flowing, or railroads. Then grip the nib and feed with thumb and forefinger, remove as a unit. Check the underside of the nib and the surface of the feed – usually the ink hasn’t travelled all the way to the tip. That’s your clue that there’s something off with the flow.

  • Make sure you’ve scrubbed the Zebra G nib (the old toothbrush/toothpaste trick) or primed it with flame to remove the factory oils. (Yes, just like when you’re using it with a dip pen holder.)
  • Inspect the feed to make sure there’s no dirt or particles caught in the feed channel or fins. Scrub the feed too.
  • Don’t take any chances with fancy ink. Use an ink known for wet flow – my favorite is Pilot Blue Black.

flowissues

Also be careful when deepening the feed channel – but almost always, you’ll have to.

Zebra G nibs have very sharp tips. They can snag on paper and sometimes, a tiny tiny bit comes off. When your nib feels very rough on paper, it’s time to move on to the next. In the image below, the bottom nib will no longer write as well – one tine is already shorter than the other.

tips

This hack is totally worth it if you’re after a consistent flexible nib experience and enjoy tinkering! Plus, you’ll learn a whole lot about the interaction amongst nib, ink, feed and paper, lessons which you can apply to any pen.

twopens

Two down, five more to play with!

allthepens

I bought the Ranga pens from Pengrafik, and the Zebra G nibs from Jetpens.